Stitches Over Tea
RUEN
Back to the home page

Pattern fitting

How to shorten flared trousers without losing the flare

It’s easy to go straight for the scissors: off comes the extra length, and suddenly the hem isn’t as wide as you wanted. Let’s try the trousers on, pin them up, and take a look first. Filya can keep an eye on the scissors.

Jump to the steps
Filya next to flared trousers

What you’ll need

  • Paper pattern or basted trousers
  • Shoes for the fitting
  • Tape measure and sewing clips
  • Paper, ruler and tape

Four fit checkpoints

A club diagram, not a cutting pattern. Check the trousers from the front and side; comfort matters more than matching the drawing.
  1. Waist: sits without pulling
  2. Hips: move without straining
  3. Knee: mark where the flare starts
  4. Hem: check the length with your shoes

Let’s take it step by step

  1. Try them on with the shoes you’ll wear. Make sure the waistband sits where it should. On a test pair or basted trousers, fold the extra length to the inside and clip it in place. Check the front, sides and back in the mirror, then take a few steps. The fabric shouldn’t drag or catch under your heel.
  2. See where the flare starts. If you cut a noticeable amount off the bottom, the new edge ends up on a narrower part of the leg. Like the length of your pinned sample but not the hem width? Adjust the paper pattern before cutting the fabric rather than trimming the bottom of the leg.
  3. Make the same adjustment to both pattern pieces. If the front and back have a leg lengthen/shorten line, work there. Cut the paper, overlap the pieces by the amount you want to remove, and line up the grainline arrows. Smooth the side seam and inseam lines. The original hem stays intact, but check the shape and fit on a test pair. Printing a PDF? Check the scale
  4. Mark the finished edge, then leave a hem allowance. The fold you clipped is the finished hemline, not the cutting line. Leave room below it for your chosen hem finish. If the folded allowance pulls the flare in or bunches up, don’t force it flat: test a narrower hem on a scrap first.

Prefer a ready-made pattern?

Affiliate link: the club may earn a commission if you subscribe through it.